Server Technology switched pro2 User Manual - page 114
Switched PRO2 – User Guide
Using the Web Interface
•
114
3. Local Administrator Account: Removes the last local administrator account when remote authentication
(LDAP, TACACS+, or RADIUS) is in use. Only a remotely-authenicated administrator can remove the last
local administrator account.
Accept the “Required” option (default), or select “Optional”. Selecting “Optional” disables the restriction to
remove the last local administrator, and also enables the Configuration Reset Button.
In turn, disabling the Configuration Reset Button automatically changes the Local Administrator Account
to “Required”. When this change occurs, if no local administrator accounts are present, the Configuration
Reset Button will be set back to enabled.
Both the Local Administrator Account drop-down and the Configuration Reset Button turn the other field on
if one of them has an Optional setting or is unchecked (disabled).
Note: For PRO2 or PRO1 units only. If LDAP, TACACS+, or RADIUS is unreachable,
or if LDAP, TACACS+, or RADIUS
parameters have changed, you may not be able to log into
the PRO2 or PRO1 unit.
3. Strong Passwords: From the drop-down menu, select Optional or Required. The PRO2 supports strong
passwords for enhanced system security. From the Strong Passwords drop-down menu, select Optional or
Required. If Required, the strong password requirement is applied against all new passwords with the
following rules:
• Minimum of 8 characters long, at least one uppercase letter, at least one lowercase letter, one number,
and one special character.
• When a strong password is changed, a minimum of four characters positions must be changed to
define the new password.
4. Custom CLI Prompt: Type a custom text string for the Command Line Interface (CLI) prompt, or leave blank
for the de
fault prompt “Switched CDU:”
5. CLI Session Timeout: Enter a timeout period (in minutes). The valid timeout range is 1 to 1440 minutes (24
hours); the default is 5 minutes.
6. Web Session Timeout: Enter a timeout period (in minutes). The valid timeout range is 1 to 1440 minutes
(24 hours); the default is 5 minutes.
7. Web Log Entries Per Page: Set the number of entries displayed on the system log, from 10 to 250.
8. Default Log Order: From the drop-down menu, specify the order of the event entries on the system log
–
oldest events or newest events displayed first in the log.
9. StartUp Stick: Check (or uncheck) to enable (or disable) StartUp Stick
. StartUp Stick is a separate Server
Technology tool for streamlining the mass configuration of PDU operating parameters.
10. Click Apply.