Server Technology switched pro2 User Manual - page 157
Switched PRO2 – User Guide
Using the Command Line Interface (CLI)
•
157
set email
Sets email configuration values.
Command Syntax
set email auth [disabled | enabled]
set email config [disabled | enabled]
set email [disabled | enabled]
set email event [disabled | enabled]
set email fromaddr
set email power [disabled | enabled] See
Note
below.
set email smtp authtype [any | crammd5 | digestmd5 | login | plain | none]
set email smtp host
set email smtp password
set email smtp port
set email smtp usefromaddr
set email smtp username
set email smtp useusername
set email test
set email toaddr1
set email toaddr2
set email trendfiles [disabled | enabled]
set email usesubjloc
set email usesubjdef
Note: The set email power command is for Switched products only.
Parameters
The set email command uses the following parameters:
auth
Sets if authentication log messages are relayed by email
config
Sets if configuration log messages are relayed by email.
event
Sets if event log messages are relayed by email.
fromaddr
Sets the email address the messages are relayed from.
0-48 characters.
power
Sets if power log messages are relayed by email.
authtype
Sets the type of authentication to use when logging into the relay SMTP
server.
host
Sets the host where the relay SMTP server is located.
0-63 characters.
password
Sets the password for logging into the relay SMTP server
0-32 characters.
port
Sets the port number for the relay SMTP server, 1-65535 (default 25).
toaddr1
Sets the first address to send email messages to. 0-48 characters.
toaddr2
Sets the second address to send email messages to. 0-48 characters.
trendfiles
Sets the preference to have new trending report files sent out daily to
both “toaddrr” addresses at midnight.