3Com OfficeConnect 3C100XF Cli User's Manual - page 108
12-20
C
HAPTER
12: IP R
OUTING
C
OMMANDS
Send Compatibility
- Controls the selection of destination MAC and IP
addresses. It is
enabled
by default. When enabled,
broadcast
address is used;
when
disabled
,
multicast
address is used.
RIP V1 Receive
- Controls the receipt of RIP version 1 updates. When RIP
version 1 is the selected routing protocol, this policy is
enabled
by default,
which means RIP version 1 packets are received. When RIP version 2 is chosen,
this policy is
enabled
by default, meaning RIP version 1 packets are received.
RIP V2 Receive
- Controls receipt of RIP version 2 updates. When RIP v1 is the
selected routing protocol, this policy is
enabled
by default, which allows RIPV1
packets to be received. When RIP version 2 is selected, this policy is
enabled
by
default, allowing RIPV2 packets to be received. RIPV2 is backward compatible.
Silent
- This flag tells RIPv2 not to send updates. It is
disabled
by default
set ip pool
Modifies IP pool parameters set using the
add ip pool
command. This command
has the following parameters:
initial_pool_address
max_unused_addrs
route
[aggregate | no_aggregate |multiple_aggregate]
size
state
[public | private]
.
set ip route
or network address> Modifies the IP route created using the add ip route command. This command has the following parameters: gateway metric Parameters Description Designation of the IP pool. The limit is 16 ASCII characters. initial_pool_address/s ubnet_mask First IP address to be assigned from the specified pool, in the format nnn.nnn.nnn.nnn, with or without a mask specifier. The mask specifier can be ‘A’, ‘B’, ‘C’, ‘H’, or a numeric value from 8 to 30 (32 for host) that describes the number of one bits in the mask. If you do not specify a mask, OfficeConnect Gateway will generate the natural netmask from the initial_pool_address . max_unused_addrs This parameter specifies the maximum number of IP address that will be wasted (unused) when multiple aggregate IP routes are created. This field is only valid if route type is multiple_aggregate . The range is 0-4096 . route Broadcasts the pool as a single network (aggregate), individual host routes (no_aggregate), or multiple networks (multiple_aggregate). The default is No_aggregate . size Number of allowable IP addresses. Class C values exceeding x.x.x .255 will increment to x.x. 1.1. The default is 1 . The range is 1-4096 . state Type of pool created. A public pool allocates IP addresses to any caller not assigned a pool; a private pool is limited to specified users. The default is Public .