3Com OfficeConnect 3C100XF Cli User's Manual - page 202
25-10
C
HAPTER
25: SNMP C
OMMANDS
Show Commands
This section describes the following Set-related SNMP commands:
show snmp
show snmp community_pool
show snmp trap_community_pool
show snmp counters
show snmp
The show snmp command
displays whether the SNMP Authentication Traps
setting is
enabled
(
or
disabled
) to indicate authentication-failures. The default is
enabled
.
Also see the
disable snmp authentication traps
and
enable snmp
authentication traps
commands.
show snmp
community_pool
The
show snmp community_pool
address of the specified SNMP community address pool.
It lists the following information:
Also see
add snmp community_pool
pool_name
>
.
show snmp
trap_community_pool
The
show snmp trap_community_pool
specified SNMP trap community and IP addresses of associated trap communities
defined using the
add snmp trap_community
following information:
show snmp counters
The
show snmp counters
command displays many SNMP statistics. The
information is organized into Input and Output Counters categories.
Input Counters:
Packets
- number of SNMP packets received
Bad Versions
- SNMP messages for an unsupported SNMP version
Bad Community Names
- SNMP messages which used an unknown SNMP
community name
Bad Community Uses
- SNMP messages which represented an SNMP
operation not allowed by the SNMP community named in the message
ASN.1 Parse Errors
- sum of ASN.1 or BER errors
Too Big Errors
- SNMP PDUs for which the value of the error-status field is
`tooBig'
Community Pool
shrewsbury
132.113.122.188
Community Pool sayhey
2.2.2.2
2.2.2.3
2.2.2.4