3Com OfficeConnect 3C100XF Cli User's Manual - page 40
3-4
C
HAPTER
3: A
DMINISTRATIVE
CLI C
OMMANDS
Show Command
show ntp
The
show ntp
command displays the Simple Network Time Protocol settings.
show ntp settings
For example:
Also see the
set ntp
command.
System Information
Commands
The following table identifies the System Information related CLI commands.
Set Command
set system
The set system command lets you specify the following system information
parameters:
name
location
contact
transmit_authentication_name
This command specifies system information which can be displayed using the
show system
command. The system information parameters are described in the
following table.
Parameters
Description
timeout
Number of seconds since a request has been sent to a server, after which
period the request is considered timed-out. The range is
1 second - 1
minute
. The default is
10 seconds
.
Primary Server is
titanic
Secondary Server is:
queenmary
Status
ENABLED
Polling Interval (Seconds)
600
Max Retransmissions
5
Retransmission Timeout:
10
Command Type
Command Name
Set
set system
Show
show system
show configuration
show system
show memory
show memory utilization
Parameters
Description
contact
Name of OfficeConnect Gateway
administrator.
location
Site of the OfficeConnect Gateway.
name
Designation of your OfficeConnect Gateway.