3Com OfficeConnect 3C100XF Cli User's Manual - page 230
28-4
C
HAPTER
28: TFTP C
OMMANDS
Also see the
disable tftp request
enable tftp request
list traceroute
commands.
Delete Commands
This section describes the following Delete-related TFTP commands:
delete tftp client
delete tftp request
delete tftp client
The
delete tftp client
command removes the specified IP host name or IP address
from the list of addresses authorized to use TFTP. Use the
list tftp clients
command to see the currently allowed addresses.
delete tftp request
Removes specified TFTP entries in the TFTP Client Request Table created with the
add tftp request
command.
Enable Commands
enable tftp request
The
enable tftp request
command activates a request for service (get or put)
from the TFTP server created with the
add tftp request
command. Use the
list
tftp request
command to display TFTP request status.
Also see the
add tftp request
disable tftp request
list traceroute
commands.
Disable Commands
disable tftp request
The
disable tftp request
command deactivates a request for service (get or put)
from the TFTP server created with the
add tftp request
command.
Also see the
add tftp request
enable tftp request
list traceroute
commands.
Set Commands
The
set tftp request
command configures requests to the TFTP server created
with the
add tftp request
command. Entries placed in the TFTP Client Request
Table are the names of files that are either requested
from
or sent
to
the TFTP
server.
set tftp request
The following parameters are associated with this command:
action
[get | put]
max_timeout
mode
[ascii | octet]
rexmt_timeout
max_timeout
Interval in seconds OfficeConnect Gateway waits for a response from
the TFTP server before the TFTP request is cancelled. The range is
1-300
. The default is
25 seconds
.
Parameters
Description