3Com OfficeConnect 3C100XF Cli User's Manual - page 194
25-2
C
HAPTER
25: SNMP C
OMMANDS
Add Commands
This section describes the following Add-related SNMP commands:
add snmp community
add snmp community_pool
add snmp trap_community
add snmp trap_community_pool
addresses
add snmp community
The
add snmp community
SNMP-authorized users.
The following parameters can be configured for the
add snmp community
command.
address
access
[ro | rw | adm]
community_pool
validate_address
[use_address | use_pool]
If you don't want to restrict SNMP access to a particular IP address, specify the
address as "0.0.0.0" (public). The community name and IP address of SNMP
requests from administrators on the network must match the list, which you can
view using the
list snmp communities
command. The following table describes
the parameters associated with the
add snmp community
command.
add snmp
community_pool
The
add snmp community_pool
SNMP Community address Pool table. This command is used in conjunction with
the
add snmp community
command to allow multiple management station
control of the OfficeConnect Gateway through a pool of IP addresses. The
following parameter can be configured for the
add snmp community_pool
command.
Parameter
Description
Group name that authorizes SNMP requests.
address
IP address of the remote SNMP manager, in the form
nnn.nnn.nnn.nnn
access
Determines what type of access to SNMP MIBs the specified user has.
Options:
Read Only (
RO
) - user-level objects
Read Write (
RW
) - user-level objects
Administrator (
ADM
) - Administrator allows
read access to all objects
and
write access to all writable objects
.
RO
is the default on public
(0.0.0.0) networks and
RW
the default on private networks.
community_pool
Name of the SNMP community pool to use.
validate_address
When set to
use_address
the
address
of the SNMP community is used to
validate the management station’s IP address. When set to
use_pool
,
the management station’s IP address is validated against the list of IP
address associated with the
community_pool
. The default is
use_address
.