3Com OfficeConnect 3C100XF Cli User's Manual - Oice
7
V
OICE
AND
V
O
DSL C
OMMANDS
Overview
If your OfficeConnect Gateway is equipped to handle data and voice, you can use
it to receive both voice traffic and data traffic over your DSL line.
This chapter identifies the Voice and Voice over DSL (VoDSL) commands that can
be accessed from the CLI of the OfficeConnect Gateway. The information in this
chapter is organized into two sections:
Voice Interface Commands
VoDSL Commands
Voice Interface
Commands
This section identifies and describes the Voice Interface commands accessible from
the OfficeConnect Gateway CLI. The following table identifies these commands:
Set Command
set voice interface
Use this command to set the following parameters for a voice interface.
txgain
>
rxgain
state
[closed
|
idle
|
voice
|
fax
|
dtmf | modem]
ring_frequency
[alert_tone 1
|
alert_tone 2
|
alert_tone 3
|
alert_tone 4
|
alert_tone 5
|
alert_tone 6
|
alert_tone 7
|
alert_tone 8
|
alert_tone 9
|
alert_tone 10
|
alert_tone_silent]
ring_cadence
[minus_r_ring
|
pattern_a_ring
|
pattern_b_ring
|
pattern_c_ring
|
pattern_d_ring
|
pattern_e_ring
|
pattern_f_ring
|
minus_t_ring
|
plus_r_ring
|
plus_t_ring
|
pattern_g_ring]
echo_canceller
[enable
|
disable]
Command
Type
Command Name
List
list voice interfaces
Set
set voice interface
Show
show voice interface
show voice interface
show all voice interfaces