3Com OfficeConnect 3C100XF Cli User's Manual - Ppp C
17
PPP C
OMMANDS
Overview
This section describes the PPP (Point-to-Point Protocol) commands accessible from
the CLI. The Point-to-Point Protocol (PPP) is a communications protocol used to
send data across serial communication links. The PPP protocol is actually
composed of several underlying protocols.
PPP provides router-to-router and host-to-network connections over both
synchronous and asynchronous circuits.
The following table identifies the PPP commands described in this chapter.
Command
Type
Command Name
Add
add datalink ppp
Delete
delete datalink ppp interface
Enable
enable pppoe on interface
enable datalink ppp interface
enable ppp acct_for_abnormal_disc
enable ppp address_field_compression
enable ppp receive_accm
enable ppp protocol_field_compression
Disable
disable ppp acct_for_abnormal_disc
disable ppp address_field_compression
disable ppp protocol_field_compression
disable ppp receive_accm
disable datalink ppp interface
Set
set ppp
Show
show ppp
show ppp settings