3Com OfficeConnect 3C100XF Cli User's Manual - page 200
25-8
C
HAPTER
25: SNMP C
OMMANDS
Validate Address
- Method selected to determine access to this trap
community. The
use_address
command uses a specified IP address to validate
access,
use_pool
uses a list of IP addresses to validate access.
The information displayed by this command is shown in the following example.
list snmp
trap_community_pools
The
list snmp trap_community_pools
command displays all SNMP trap
community pools in the SNMP Trap Community Address Pool defined using the
add snmp trap_community_pool
command.
The following information is displayed when this List command is used:
Name
- designation of the trap community pool
Number of Addresses
- Sum of IP addresses associated with the specified trap
community pool
Set Commands
This section describes the following Set-related SNMP commands:
set snmp communities
set snmp trap community
set snmp community
The
set snmp community
community (authorized user or host to which notifications are sent) configured
with the
add snmp community
name and IP address of SNMP requests from managers on the network must
match the list, which you can view using the
list snmp communities
command.
The following parameters are associated with the
set snmp community
command:
access
[ro | rw | adm]
address
community_pool
validate_address
[use_address | use_pool]
SNMP TRAP COMMUNITIES
Community Name
IP Address
Community Pool
Validate
Address
Kensington
useAddress
Kerby
usePool
Kenwood
1.1.1.3
useAddress
TRAP COMMUNITY POOLS
Name
Number of
Addresses
Joisy
5