3Com OfficeConnect 3C100XF Cli User's Manual - page 174
20-2
C
HAPTER
20: N
ETWORK
S
ERVICES
C
OMMANDS
The parameters of the
add network service
command are described in the
following table:.
The following table shows the configurable values for network service, which are
specified with the
data
parameter.
Parameters
Description
Name of this type of service. The limit is
32 ASCII
characters.
close_active_
connections
Indicates whether or not to close any active connections when a service
is disabled by the
disable network_service
command. The default is
False
.
data
Ancillary Data. This field contains server-specific configuration data. See
table below for configurable ancillary data values for TELNET.
enabled
Optional
. Indicates whether the network is enabled (
YES
) or disabled
(
NO
). When you add a network service, it is
enabled
by default.
server_type
Designates the type of service being offered. Services currently available
are:
SNMPD
- Daemon supports SNMP. Uses UDP.
TFTPD
- Daemon supports file transfer service. Uses UDP.
TELNETD
- Daemon supports TELNET, to the CLI. Uses TCP.
socket
Port the server listens on. For TFTP and TELNET, it is the TCP or UDP port
number. Socket numbers are the joined sender’s (or receiver’s) IP
address and service type’s port number. The maximum is
65535.
The
range is
0-65535
.
Ancillary Data
Values
Description
auth
On indicates that login/password authentication should be performed on
incoming connections.
Format:
auth= [on | off]
The default is
on
.
drop_on_hangup
Value specifying whether the TCP session is dropped after modem hangs
up.
Off
allows connection to remain active.
The default is
off
.
login_banner
ASCII string sent to a client when connection is made. It must be quoted
and offset by backslashes if spaces are included in the string. Specify
carriage return after login banner with
login_banner=string\r\n\.
The format is
login_banner=string
The default is
none
.
login_prompt
ASCII string specifying the login prompt sent during authentication. It must
be quoted and offset by backslashes if spaces are included in the string.
Specify a carriage return after the login banner with
login_banner=string\r\n\
.
The format is
login_prompt=string
The default is
login
:.
service_type
Indicates whether the service offered is modem sharing or manage.
Modem sharing
service
connects a client to
multiple
modems.
Manage
service connects a client to the
command line
, to manage the
system. Applicable only to TELNET servers; you can’t use ClearTCP to
access the system for management.
Format:
service_type=manage, dialout
The default is
manage
.