3Com OfficeConnect 3C100XF Cli User's Manual - page 110
12-22
C
HAPTER
12: IP R
OUTING
C
OMMANDS
set ip
source_based_routing
enabled
[no | yes]
This command enables or disables source based routing on the specified interface.
set ip source route
Change parameters in the routing table for the specified IP source route. This
command has the following parameters:
gateway
metric
Show Command
show all ip networks
Displays details for all configured IP networks.
show ip counters
Displays system-wide IP network statistics.
Input Counters
Parameter
Description
interface_name
The name of the interface to which to apply this command.
enabled
no
- Do not allow source based routing on this interface.
yes
- Allow source based routing on this interface.
Parameter
Description
ip_name_or_net_addr
The network name or IP address of the source route to be changed
gateway
The network name or IP address of the gateway to which IP
datagrams with the specified source address should be routed.
metric
This specifies how many hops it is to the specified gateway.
SHOW IP
NETWORK ip SETTINGS:
Interface:
eth:1
Network Address:
151.104.196.166/C
Frame Type:
ETHERNET_II
Status:
ENABLED
Reconfigure Needed:
FALSE
Mask:
255.255.255.0
Station:
151.104.196.166
Broadcast Algorithm:
IETF
Max Reassembly Size:
8192
WAN Type:
N/A
Remote IP Address:
0.0.0.0
IP Routing Protocols:
NONE
IP Routing Metric:
1
RIP Interface Export
Metric:
0
IP RIP Routing
Policies:
IP RIP Authentication
Key: