3Com OfficeConnect 3C100XF Cli User's Manual - page 229
Add Commands
28-3
Status
- State of each current TFTP request in the table:
Normal
- Request is in the table or has been successfully completed
Getting
- Initial state: TFTP server is receiving a file
Putting
- Initial state: TFTP server is sending a file
Error
- Request has finished unsuccessfully and will generate an error
message
Add Commands
This section describes the following Add-related TFTP commands:
add tftp client
add tftp request
add tftp client
The
add tftp client
command adds the
tftp client
to the Authorization Table for
TFTP access.The parameters for this command are described in the following table.
add tftp request
The
add tftp request
command adds entries to the TFTP Client Request Table.
Entries are the names of files either requested
from
or sent
to
the TFTP server. The
command is useful for administrators seeking to access the TFTP client
OfficeConnect Gateway. The following parameters are associated with this
command:
action
[get | b]
server
mode
[ascii | octet]
rexmt _timeout
max_timeout
These parameters are described in the following table.
TFTP REQUEST TABLE
Filename
Server
Action
Status
filter.in
Scylla
PUT
NORMAL
OCG
Styx
GET
GETTING
Parameters
Description
Host name or IP address of a host to be added. An address of
0.0.0.0 allows all clients TFTP access.
Parameters
Description
Designation of file to be requested from or sent to the TFTP server. The
limit is
32
ASCII characters.
action
Type of request sent to the TFTP server. Choices:
put
or
get
server
Name or IP address of the TFTP server.
mode
The text format the file is transmitted as. Choices:
ascii
or
octet
(binary). The default is
ascii
.
rexmt_timeout
Retransmission timeout - interval in seconds OfficeConnect Gateway
waits for a reply from the TFTP server before retransmitting a TFTP
request. The range is
1-60
. The default is
5 seconds
.