3Com OfficeConnect 3C100XF Cli User's Manual - page 149
Address Translation
16-7
Private addresses refer to addresses on the LAN
Public addresses refer to addresses on the WAN
atmaal:1/PVC-67-0-35)
Static NAT
To configure Static NAT from the CLI for a PPPoE User, perform the following
steps:
1
Enter the following CLI commands.
OCG-Adsl>>add profile
network_service pppoeC_ATM_RFC1483
OCG-Adsl>>set profile
send_password
OCG-Adsl>>set profile
bridging_disable
2
Enter one of the following CLI commands next:
If using dynamic IP addressing (the most common situation), enter the
following CLI command to make the OfficeConnect Gateway automatically
negotiate for an IP address:
OCG-Adsl>>set profile
protocol ip
address_selection negotiate
If you know the specific local and remote IP addresses, enter the following CLI
command where
x.x.x.x
is the local IP address and
y.y.y.y
is the remote IP
address.
OCG-Adsl>>set profile
protocol ip
local_ip_address
remote_ip_address
OCG-Adsl>>)set profile
protocol ip default_route_option
enable routing both routing_protocols ripv2
OCG-Adsl>>) add atmaal5 pvc
vpi
vci
OCG-Adsl>> add datalink ppp interface