3Com OfficeConnect 3C100XF Cli User's Manual - page 97
Disable Commands
12-9
enable ip
address_pool_filtering
Permits packet filtering on all IP address pools. Use the
show ip
command to view
the current setting
enable ip
address_pool_round_robi
n
Turns on round robin allocation of IP addresses from IP address pools configured
with the
add ip pool
command. Use the
show ip settings
command to view the
current setting. The default is
enabled
.
enable ip forwarding
Allows all IP networks to forward (route) packets.
enable ip
multicast_heartbeat
Enables multicast monitoring for a specified multicast group or interface.
enable ip network
Enables the specified IP network, which you previously defined using the
add ip
network
command. You can use the
list ip networks
command to see the
currently defined IP networks, as well as their current status.
enable ip rip
Enables the RIP protocol for all IP networks. RIP protocol is set to NONE by default.
enable ip
source_address_filter
Enables filtering of packets that bear a source IP address other than that assigned
by the OfficeConnect Gateway during negotiations. This should not be enabled
for LAN-to-LAN routing. This feature works for PPP users. This feature is disabled
by default.
enable ip
static_remote_routes
Enables statically defined remote routes, which are defined with the
add ip route
command.
Disable Commands
disable ip
Disables the following IP parameters:
address_pool_filtering
network
send_host_unreach_for_pool
address_pool_round_robin
proxy_arp_all_dialin
send_unsolicited_arp
directed_bcast_forwarding
respond_to_directed_bcast
source_address_filter forwarding
rip
static_remote_routes
multicast_heartbeat
security_option