3Com OfficeConnect 3C100XF Cli User's Manual - page 55
Show Commands
4-5
Type
- type of configured user. See the
add user
command for more
information.
Show Commands
This section describes the show user and show
show user
The
show user
specified user.
settings
all_settings
settings
- Displays settings for the specified user with the exception of
disabled IP, Tap Status and Tunnel Type
parameters.
all_settings
- Displays
all
settings for the specified user.
The type of information displayed depends on the type of user you specify. You
can issue the
list users
command to see which users are defined, and what
type(s)
user each is. An example of the information displayed for a user is shown in the
following table. Note that this user may not be typical. Defaults are indicated by
(D)
. set maximum_local_users
USERS
Login
Network
User Name
Service
Service
Status
Type
curly
TELNET (D)
PPP (D)
ACTIVE
LOGIN
DIALOUT
MANAGE
default
TELNET
PPP
INACTIVE
NETWORK
administrator
TELNET (D
PPP (D
ACTIVE
LOGIN
MANAGE
INFORMATION FOR USER: joeadmin
Status:
ACTIVE
Type:
LOGIN
NETWORK
TUNNEL
MANAGE
Expiration:
NONE
DNIS Re Authentication:
REAUTH_ANY
Special Xon Xoff Flow Control
DISABLED
NAT Option:
INVALID
Intelligent NAT State:
DISABLED
Intelligent NAT default
workstation:
0.0.0.0
Policy Filename:
Telnet Options:
None
Input Filter:
(D)
Output Filter:
(D)
Session Timeout in seconds:
0 (D)
Idle Timeout in seconds:
0 (D)
Tap Status:
DISABLED
Tap Format:
ASCII