3Com OfficeConnect 3C100XF Cli User's Manual - page 64
6-2
C
HAPTER
6: B
RIDGING
C
OMMANDS
Bridging Commands
The following table identifies the Bridging commands accessible from the
OfficeConnect Gateway CLI:
Remember to save your configuration using the
save all
command before
rebooting your OfficeConnect Gateway so that your changes will be written to
permanent FLASH memory.
Configure Bridging for
the LAN and WAN
To configure a protocol over the LAN, you need to assign a protocol network to
the LAN port by providing it with a name. After adding a network, you can modify
the advanced parameters.
Use the following CLI commands to configure bridging for the LAN and WAN:
add bridge network
Use the
add bridge network
network over the Ethernet interface.
list networks
Use the
list networks
command to obtain a list of all configured networks.
list bridge networks
Use the
list bridge
networks command to only list bridge networks.
Command
Type
Command Name
Add
add bridge network
network name
>
Delete
delete bridge network
network name
>
Enable
enable bridge spanning_tree
Disable
disable bridge network
network name
>
disable ip forwarding
disable bridge spanning_tree
List
list bridge networks
list bridge forwarding
Set
set bridge aging_time
set bridge forward_delay
set bridge spanning_tree_priority
set bridge firewall discard_routed protocols
set bridge firewall fwd_unicast_only
set bridge firewall fwd_bc_and_unicast
Show
show ip settings
show bridge settings
show bridge network