3Com OfficeConnect 3C100XF Cli User's Manual - Onfiguring
4
C
ONFIGURING
AND
M
ANAGING
U
SERS
Overview
This chapter identifies and describes the CLI commands you can use to configure
and manage the authorized users of the OfficeConnect Gateway.
You can configure all remote networking parameters associated with the profile of
the user who is accessing the OfficeConnect Gateway. A user profile specifies the
user’s protocol, address parameters, and other unique settings.
The following table identifies the commands that can be used for configuring and
managing users of the OfficeConnect Gateway:
Add Commands
add user
The
add user
specify a type for the user, as well as the login protocol, or use the defaults.
The following parameters are associated with this command:
enabled
[yes | no]
login_service
[rlogin | telnet]
password
type
[login, network, manage, manage_readonly]
Command
Type
Command Name
Add
add user
> add address_pool user Delete delete user > delete address_pool user Enable enable user > Disable disable user > Disconnect disconnect user List list users Set set user > set framed_route user set maximum_local_users Show show user >