3Com OfficeConnect 3C100XF Cli User's Manual - page 154
17-2
C
HAPTER
17: PPP C
OMMANDS
Add Command
add datalink ppp
Use this command to add a user to the PPP data link layer. This command has the
following parameters:
enabled
[no | yes]
interface
profile
Delete Commands
delete datalink ppp
interface
Removes the PPP data link layer defined on top of the physical WAN interface. You
can list currently defined PPP datalink enabled interfaces using the
list ppp
command.
Enable Commands
enable datalink ppp
interface
Enables PPP as the datalink layer protocol to run on the specified interface. You
must have previously run
add datalink ppp
in order for this command to work.
You can list currently defined PPP datalink enabled interfaces using the
list ppp
.
command
.
enable ppp
acct_for_abnormal_disc
Enables the sending of an Accounting Stop record when a call is abnormally
disconnected before a Start Record is sent.
enable ppp address_field_
compression
Enables PPP address field compression. The default is
enabled
.
enable ppp receive_accm
Enable strict checking of receive side ACCM mapping for incoming PPP data
packets. It checks whether all the control characters which need to be mapped are
mapped in all data packets.
enable ppp
protocol_field_
compression
Enables PPP protocol field compression. The default is
enabled
.
Parameters
Description
enabled
Enable or disable the user.
Value is
enabled
or
disabled
.
interface
The name of a valid interface. The limit is
32 ASCII characters
.
profile
A valid user name. The limit is
64 ASCII
characters.