3Com OfficeConnect 3C100XF Cli User's Manual - page 162
18-2
C
HAPTER
18: PPP
O
E C
OMMANDS
PPPoE Commands
The following table identifies the PPPoE commands that can be used after a PPPoE
session has been created.
Add Command
add pppoe service_name
During the discover stage of the PPPoE protocol, the PPPoE client may request a
connection with the OfficeConnect Gateway indicating the service name that it
requires. The service name is typically the name of the ISP or any Quality of Service
(QOS) parameters.
Presently the service names are just strings with no QOS significance attached. The
client may send a service name as a NULL string indicating that any service is
acceptable in which case no service names need to be configured in the
OfficeConnect Gateway. If the client request contains a non-null service name in
the request, then the same name has to be configured in the OfficeConnect
Gateway.
Delete Command
delete pppoe
service_name
Removes the designated PPPoE service name.
Enable Command
enable pppoe on
interface
This command enables the specified interface to send and receive frames carrying
the new ether-type defined by the PPPoE protocol.
Disable Command
Command
Type
Command Name
Add
add pppoe service_name
Delete
delete pppoe service_name
Enable
enable pppoe on interface
Disable
disable pppoe on interface
Set
set pppoe
max_sessions
max_sessions_per_host
List
list pppoe
list virtual connections
Show
show pppoe
[counters | settings]