3Com OfficeConnect 3C100XF Cli User's Manual - page 155
Overview
17-3
Disable Commands
disable ppp
acct_for_abnormal_disc
Disables the sending of an Accounting Stop record when a call is abnormally
disconnected before a Start Record is sent.
disable ppp
address_field_
compression
Disables PPP address field compression. The default is
enabled
.
disable ppp
protocol_field_
compression
Disables PPP protocol field compression. The default is
enabled
.
disable ppp receive_accm
Disables strict checking of receive side ACCM mapping for incoming PPP data
packets. It checks whether all the control characters which need to be mapped are
mapped in all data packets.
disable datalink ppp
interface
interface_name>
Disables the administrative state of the PPP DLL created on top of the physical
WAN interface. You can list currently defined PPP datalink enabled interfaces using
the
list ppp
command.
Set Command
set ppp
Sets global parameters for PPP which applies to all calls including the call type for
which PPP compression will be attempted/accepted. Issuing this command
overrides the
compression algorithm
parameter set by the
set network user
ppp
command.
Users who dial in and receive a compressed_analog connection (MNP5 or V.42bis)
won’t receive PPP compression. Payload compression is set by the parameter - not
header compression as set for a user.
The set ppp command has the following parameters:
authentication_preference
[chap | default | eap | ms_chap | pap]
bap_hunt_group_phone_number
ccp_modemtype_accept
[none | all | digital | compressed_analog |
uncompressed_analog | pppoe]
dns_usage
[system | ppp | none]
nbns_primary
nbns_secondary
pppdns_primary
pppdns_secondary
receive_authentication
[none | pap | chap | any | eap | ms_chap |
any_except_mschap | encrypted_any]
session_start_message
system_mtu
These parameters are described in the following table.