3Com OfficeConnect 3C100XF Cli User's Manual - page 95
Delete Commands
12-7
add ip source route
gateway
metric
The OfficeConnect Gateway supports routing based on source addresses of IP
datagrams. When source based addressing is enabled, the IP packets coming in on
a static interface are looked up in the routing table based on the source address
instead of the destination address and routed accordingly. If source address lookup
fails, the destination address is looked up and if that fails the default route is used.
Static routes must be added in the OfficeConnect Gateway for the desired source
addresses. The routes may be host routes or may be qualified with a net-mask.
These routes are not propagated via RIP. The feature can be turned on for a static
interface (Ethernet, leased line, etc.) and all incoming IP datagrams are routed
based on source addresses.
Delete Commands
delete ip defaultroute
gateway
name> Deletes the IP default route created with the add ip defaultroute gateway command. Use the list ip routes command to verify edit. delete ip network Deletes an IP network from the interface that you specified when adding the network. Use list ip networks to see which networks are associated with which interfaces. Always use disable ip network before deleting it . delete ip pool name> Deletes an IP pool created with the add ip pool command. Use the list ip pools command to verify edit. initial_pool_address/su bnet_mask First IP network address to be assigned from the specified pool, in the format nnn.nnn.nnn.nnn , with or without a mask specifier. The Mask Specifier can be ‘A’, ‘B’, ‘C’, ‘H’ , or a numeric value from 8 to 30 ( 32 for host) that describes the number of one bits in the mask. If you do not specify a mask, OfficeConnect Gateway will generate the natural netmask from the initial_pool_address . max_unused_addrs This parameter specifies the maximum number of IP address that will be wasted (unused) when multiple aggregate IP routes are created. This field is only valid if route type is multiple_aggregate . The range is 0-4096 . route Broadcasts the pool as a single network (aggregate), individual host routes (no_aggregate), or multiple networks (multiple_aggregate). The default is no_aggregate . size Number of allowable IP addresses. Class C values exceeding x.x.x .255 will increment to x.x. 1.1. The default is 1 . The range is 1-4096 . state Type of pool created. A public pool allocates IP addresses to any caller not assigned a pool; a private pool is limited to specified users. The default is Public . Parameters Description Parameter Description source route The network name or IP address of the source of the IP datagram. gateway The network name or IP address of the gateway to which IP datagrams with the specified source address should be routed. metric This specifies how many hops it is to the specified gateway.