3Com OfficeConnect 3C100XF Cli User's Manual - page 236
29-4
C
HAPTER
29: T
RACEROUTE
C
OMMANDS
list traceroute row
hops
Displays counters for specified traceroutes. It lists the following information:
Row
- entry number in the Traceroute Table. The range is
1-255
.
Hop
- number of hops taken to reach destination
IP address
- IP address of destination
Round Trip Time
- period to reach destination and return to the
OfficeConnect Gateway
Show Commands
show traceroute,
show traceroute
settings
These commands display the maximum number of traceroutes configurable using
the set
traceroute maximum_rows
command. See
traceroute, list traceroute,
delete traceroute,
and
set traceroute maximum_rows
commands for more
information. For example:
show traceroute row
settings
Displays results of the specified trace (entry in the Traceroute Table) using the
traceroute
State
- Status of the specified traceroute in the table. Possible states:
WAITING DNS
- waiting for DNS resolution
DNS FAILED
- destination address could not be resolved
BAD address
- resolved IP address is illegal
HOPS EXCEEDED
- maximum number of hops was exceeded
DEST UNREACHABLE
- trace timed out because route to the host could
not be found
TRACING
- performing traceroute
COMPLETED SUCCESSFULLY
- traceroute completed successfully
RESOURCE FAILURE
- not enough resources to complete the command
Hop Timeout
- Interval in seconds before the OfficeConnect Gateway retries a
hop. The default is
3
.
Hop Probes
- maximum attempts the OfficeConnect Gateway makes to learn
a hop before moving to the next hop. The default is
3
.
Max Hops
- maximum number of hops the OfficeConnect Gateway takes to
trace before quitting. The default is
30
.
UDP Port
- The OfficeConnect Gateway port number used trying to find the
route. The default is
33434
.
Data Size
- amount of data in bytes sent in the traceroute packet. The range is
1-8184 bytes
.
ROW
HOP
IP address
ROUND TRIP TIME
1
1
11.0.0.20
100
1
2
10.0.0.2
100
Maximum Rows in Table: 20