3Com OfficeConnect 3C100XF Cli User's Manual - page 53
Disconnect Command
4-3
also causes all active sessions established using that particular user to terminate,
and does not allow any new sessions to occur using that user name.
Disabling a user is useful when prohibiting a user’s access temporarily. Use the
list
users
and
show user
commands to view edits.
Disconnect Command
disconnect user
The
disconnect user
connection.
Set Commands
This section describes the following Set commands:
set user
set maximum_local_users
set user
The
Set user
command allows you to change the configuration of the following
parameters of your user profiles.
expiration
idle_timeout
login_service
[ClearTCP, Ping, Rlogin, Telnet]
password
telnet_options
[binary, escape]
type
[login, network, manage, manage_readonly]
The
Set user
command allows you to change the configuration of user profile
settings, some of which may have already been configured with the
add user
command.
Parameters
Description
Name of user, previously defined using add user. The limit is
64 ASCII
characters.
expiration
Date after which this user becomes inactive. The format is
DD-MMM-[YY]YY. Month is the first 3 letters of the month. Year is
either 2 or 4 digits - 96 or 1996.
idle_timeout
Interval to wait before timing out an inactive connection. The default
is
0
(not activated). The range is
1 -
86400 seconds.
Note: Change the default to configure this value.
login_service
Service used to login to the remote host. Choices:
ClearTCP
Ping
Rlogin
Telnet
password
User’s password (optional). The limit is
127
ASCII
characters. You may
enter a null password with:
password
“”.