3Com OfficeConnect 3C100XF Cli User's Manual - page 99
List Commands
12-11
list
ip addresses
Displays the IP address for each active IP network. It lists the following
information:
address
- IP address of the interface
Bcast Algo
- Algorithm used to determine which address to broadcast
representing the entire network. Choices are:
1
- the IETF standard:
nnn.nnn.nnn.255
(
default
)
0
- the BSD standard:
nnn.nnn.nnn.000
Reassembly Max Size
- maximum allowable size of packet that can be
reassembled from a fragmented packet
Interface
- interface this IP address uses to connect to the system. Values
displayed are
internal, loopback,
or
eth:1.
list ip defaultroute
Displays default gateway IP routers, which act as default routes for IP packets
destined for remote hosts unknown to the OfficeConnect Gateway. All
unspecified routes are automatically sent to this gateway. A default route gateway
specified with a higher metric acts as the
primary
default route gateway and a
second default route gateway with a lower metric acts as the
secondary
default
route gateway. It lists the following information.
address
- IP address of the default route
Mask
- subnet mask of the default route
Gateway
- IP address of the gateway router
Metric
- hop count to the gateway
State
- status of the default route
list ip networks
Displays all the IP networks you previously defined
statically
using the
add ip
network
command and any dynamic networks created with a PPP connection to
the OfficeConnect Gateway. It also lists:
Name
- network designation
Prot
- IP protocol only
Int
- name of the LAN interface this network runs on:
eth:1, loopback,
internal, sdsl:1/
IP addresses
address
Bcast
Algo
Reassembly
Max Size
Interface
2.2.2.2/A
1
3464
internal
127.0.0.1/A
1
3464
loopback
123.145.134.140/2
2
1
3464
eth:1
Configured default routes
Address
Mask
Gateway
Metric
State
112.23.44.34
255.255.255.25
2
112.23.45
.34
3
State
112.23.44.34
255.255.255.25
2
112.23.45
.32
4
State