3Com OfficeConnect 3C100XF Cli User's Manual - Ppp
18
PPP
O
E C
OMMANDS
Overview
This section describes the PPPoE (Point-to-Point Protocol over Ethernet) commands
accessible from the CLI. The Point to Point Protocol over Ethernet (PPPoE) standard
helps access providers manage their broadband service delivery, and it can also
improve the ease of use for DSL customers.
Creating a PPPoE
Client Session
To use PPPoE you must create a PPPoE Client session by performing the following
steps:
Add a User
Set the Remote IP address
Add the datalink
Add a User
add user
To add a user, use the
add user
following parameters:
password
max_sessions_per_host
local_ip_address
send_password
network_service
| pppoec_fr_rfc1483 | pppoec_atm_rfc1483> type network Set the Remote IP address set network user remote_ip_address Use the set network user ip remote_ip_Address command to set the PPPoE client’s remote IP address. Add the Datalink add datalink ppp interface Use the add datalink ppp interface user command to add the datalink between the PPP interface and the user.