3Com OfficeConnect 3C100XF Cli User's Manual - page 234
29-2
C
HAPTER
29: T
RACEROUTE
C
OMMANDS
A row will timeout after 30 minutes and automatically be deleted. Also, a row can
be deleted at any time, regardless of its state of status.
Be aware that traceroute-generated packets received by the OfficeConnect
Gateway will not increment ICMP error counters (Time Exceeded and Destination
Unreachable).
Error messages are generated for the following reasons:
DNS Failed
- destination address could not be resolved due to timeout or
other reason
Bad address
- resolved IP address is illegal
Hop Timeout
- timeout occurred
Hops Exceeded
- maximum number of hops exceeded
Dest(ination) Unreachable
- a route to the host could not be found
Tracing
- performing traceroute
Resource Failure
- not enough resources to complete the command
The command will generate all information received up to resolution or failure.
Parameters
Description
address> IP name or address of destination to target. Maximum characters: 255 . maxhops Maximum number of hops traceroute runs before quitting. The default is 30 . The range is 1-255 . port UDP port number that the probe is sent to. The value should be an unused port on the destination host. The default is 33434 . The range is 1-65000 . retries Number of times to attempt a given hop. The range is 1-10 . size Amount of data in bytes to send in the traceroute packet. A larger data size slows down performance and provides no additional information. The default is 1 . The range is 1-8184 . timeout Interval in seconds before hop times out; not for completion of the command. The default is 3 . The range is 1-60 . HOP address ROUND-TRIP-TIME 1 154.112.254.24 100 2 154.112.254.254 100 3 154.112.124.254 100 4 154.112.170.2 100 5 154.112.79.1 200 6 154.112.63.253 100 7 153.234.24.145 200 8 137.039.037.067 250 9 Unknown 0 10 Unknown 0 11 Unknown 0 12 157.130.064.098 260 DEST UNREACHABLE