3Com OfficeConnect 3C100XF Cli User's Manual - page 109
Set Commands
12-21
.
set ip routing
Sets global parameters for IP routing on the specified IP router address which
serves as the gateway to an autonomous system. This command has the following
parameters:
autonomous_system_number
metric_maximum_entries
rip_flags
router_id
IP routing must be disabled before setting these values.
An autonomous system is a connected group of networks run by one or more
network operators which has a single and clearly defined routing policy. An
autonomous system number is a unique identifier for such a system, but is not
currently supported by the OfficeConnect Gateway
.
Parameters
Description
IP network address> IP address or host name of the remote destination, in the format nnn.nnn.nnn.nnn , entered with or without a mask specifier. The mask specifier can be ‘A’, ‘B’, ‘C’, or ‘H’ (host), or a numeric value from 8 to 30 (32 if a host) that describes the number of one bits in the mask. You can also specify the netmask in the xxx.xxx.xxx.xxx format. If you do not specify a mask, the system will self-generate it (based on the network address) for all routes except host routes, for which you must specify a mask. gateway Host name or IP address of the next hop to the specified IP network address metric Number of hops the destination is removed from the specified IP network address. The range is 1-15 . Parameters Description autonomous_system_number Value associated with a protocol not currently supported. Disregard this value. The range is 1-65535 . metric_maximum_entries Most next hop entries the Next Hop Hash Table can hold. The default is 512. The range is 256-65535 . router_id IP address of the OfficeConnect Gateway. If value not specified, the system will take a user-configured internal IP address for this value, or the eth:1 value if no internal value is specified. rip_flags Flags indicate at which level a RIP instance is disabled or configured. Choices are: Metrics - Specifies how to increment metrics using RFC1058. Send_request - Sends a RIP request for routing data when an interface first comes up.