Garmin G900X Pilot's Manual - page 113
190-00726-00 Rev. A
Garmin G900X Pilot’s Guide
3-21
ENGINE INDICATION SYSTEM
LEAN DISPLAY
The EIS Lean Display provides information and a user interface to perform engine leaning. Exhaust gas
(EGT) and head (CHT) temperatures for each cylinder are displayed in bar graph form with a readout for the
temperature of the selected cylinder shown below each graph. Turbine inlet temperature (TIT) is also shown
for turbocharged aircraft.
Accessing the EIS Lean Display:
1)
Select the
ENGINE
Softkey.
2)
Select the
LEAN
Softkey.
3)
To return to the default Engine Display, select the
ENGINE
or
BACK
Softkey.
By default, the cylinder with the hottest temperature is selected (number highlighted in light blue) when the
LEAN
Softkey is selected. Bars for cylinders with temperatures in the normal range are shown in white. On
the CHT Bar Graph, a warning condition for a cylinder is indicated in red.
Since only one cylinder’s EGT and CHT are displayed at a time, this information can be cycled through for
each cylinder using the
CYL SLCT
Softkey; the selected cylinder’s number is highlighted in light blue on the
bar graphs. This softkey is disabled when Leaning Assist Mode is selected or when a cylinder experiences a
warning (red) condition; the softkey remains disabled until the temperature returns to normal.
Monitoring the desired cylinder’s temperatures:
From the Lean Display, select the
CYL SLCT
Softkey to cycle through each cylinder and view its temperature
information. The selected cylinder number is highlighted in light blue.
While in Reversionary Mode, the leaning assist function is available from the Lean Display to assist in the
leaning process.
Accessing Leaning Assist Mode:
1)
Select the
ENGINE
Softkey.
2)
Select the
LEAN
Softkey.
3)
Select the
ASSIST
Softkey to identify the peak.
4)
Select the
ASSIST
Softkey again to exit Leaning Assist Mode.