Garmin G900X Pilot's Manual - page 317
GPS NAVIGATION
190-00726-00 Rev. A
5-159
Garmin G900X Pilot’s Guide
6)
Highlight ‘LOAD?’ or ‘ACTIVATE?’. ‘LOAD’ adds the approach to the flight plan without immediately using the
approach for navigation guidance. This allows for the original flight plan to continue navigating until cleared for
the approach, but keeps the approach available for quick activation when needed. ‘Activate’ adds the approach
to the flight plan and begins navigating the approach course.
Removing an approach from a direct-to or active flight plan:
1)
From the Flight Plan Page, press the
MENU
Key.
2)
Highlight ‘Remove Departure’, ‘Remove Arrival’, or ‘Remove Approach’
3)
Press the
ENT
Key. A confirmation window appears listing the procedure that is about to be removed with ‘OK’
highlighted.
4)
Press the
ENT
Key.
Another Procedures Window option allows vectors to the final approach course.
Activating a (previously loaded) approach, with vectors to final:
1)
Press the
PROC
Key to display the Procedures Window.
2)
Highlight ‘ACTIVATE VECTOR-TO-FINAL’ and press the
ENT
Key.
In many cases, it may be easiest to “Load” the full approach while still some distance away, enroute to
the destination airport. Later, if vectored to final, use the steps above to select ‘Activate Vector-To-Final’
— which makes the inbound course to the FAF waypoint active. Otherwise, activate the full approach using
the ‘ACTIVATE APPROACH’ option.
Activating a missed approach in the active flight plan:
1)
Press the
PROC
Key.
2)
Highlight ‘ACTIVATE MISSED APPROACH’.
3)
Press the
ENT
Key. A confirmation window is displayed.
4)
With ‘ACTIVATE’ highlighted, press the
ENT
Key.