Garmin G900X Pilot's Manual - page 41
190-00726-00 Rev. A
Garmin G900X Pilot’s Guide
1-29
SYSTEM OVERVIEW
Besides character-by-character data entry, the system also provides a shortcut for entering waypoint identifiers.
When the cursor is on a field awaiting entry of a waypoint identifier, turning the small
FMS
Knob counter-
clockwise accesses three different lists of waypoint identifiers for quick selection: flight plan (FPL), nearest
(NRST), and recently-entered (RECENT). The G900X automatically fills in the identifier, facility, and city fields
with the information for the selected waypoint.
Using the MFD/PFD Control Unit keypad to enter data:
1)
Choose the desired display control mode by pressing the
PFD
or
MFD
Key on the MFD/PFD Control Unit.
2)
If needed, press the
FMS
Knob to activate the cursor.
3)
Use the large
FMS
Knob to highlight the desired field.
4)
Use the alphanumeric keys to enter the desired information.
5)
Press the
ENT
Key to confirm the entry
6)
Press the
CLR
Key to cancel data entry (the field revers back to its previous information).
Using the
FMS
Knob to enter data:
1)
If needed, press the
FMS
Knob to activate the cursor.
2)
Use the large
FMS
Knob to highlight the desired field.
3)
Begin entering data.
a)
To quickly enter a waypoint identifier, turn the small
FMS
Knob counter-clockwise to display a list of waypoints
in the active flight plan (list is titled FPL). If desired, turn the small
FMS
Knob clockwise to scroll through lists
of nearest waypoints (NRST) and recently-entered waypoints (RECENT).
b)
Turn the large
FMS
Knob to highlight the desired waypoint from the list and press the
ENT
Key.
OR
:
a)
Turn the small
FMS
Knob to select a character for the first placeholder.
Turning the knob clockwise scrolls through the alphabet (where appropriate) toward the letter Z, starting at
K, and the digits zero through nine. Afterwards, turning the knob counter-clockwise scrolls in the opposite
direction.
b)
Use the large
FMS
Knob to move the cursor to the next placeholder in the field.
c)
Repeat, using the small
FMS
Knob to select a character and the large
FMS
Knob to move the cursor, until the
field is complete.
d)
Press the
ENT
Key to confirm entry.
7)
Press the
FMS
Knob or
CLR
Key to cancel data entry (the field reverts back to its previous information).