Garmin G900X Pilot's Manual - page 127
190-00726-00 Rev. A
Garmin G900X Pilot’s Guide
4-5
AUDIO PANEL AND CNS
6
COM3
– Not used in the G900X.
7
COM 1/2
– Not used in the G900X.
8
TEL
– Not used in the G900X.
9
PA
– Selects the passenger address system. The selected COM transmitter is deselected when the
PA
Key
is pressed.
10
SPKR
– Selects and deselects the cabin speaker (if installed). COM and NAV receiver audio can be heard
on the speaker.
11
MKR/MUTE
– Selects marker beacon receiver audio. Mutes the currently received marker beacon receiver
audio. Unmutes automatically when new marker beacon audio is received. Also, stops play of recorded
COM audio.
12
HI SENS
– Press to increase marker beacon receiver sensitivity. Press again to return to low sensitivity.
13
DME
– Not used in the G900X.
14
NAV1
– When selected, audio from the #1 NAV receiver can be heard.
15
ADF
– Not used in the G900X.
16
NAV2
– When selected, audio from the #2 NAV receiver can be heard.
17
AUX
– Not used in the G900X.
18
MAN SQ
– Enables manual squelch for the intercom. When the intercom is active, press the
PILOT
Knob
to illuminate SQ. Turn the
PILOT/PASS
Knobs to adjust squelch.
19
PLAY
– Press once to play the last recorded COM audio. Press again while audio is playing and the
previous block of recorded audio will be played. Each subsequent press plays each previously recorded
block. Pressing the
MKR/MUTE
Key during play of a memory block stops play.
20
PILOT
– Selects and deselects the pilot intercom isolation.
21
COPLT
– Selects and deselects the copilot intercom isolation.
22
PILOT Knob
– Press to switch between volume and squelch control as indicated by illumination of VOL
or SQ. Turn to adjust intercom volume or squelch. The
MAN SQ
Key must be selected to allow squelch
adjustment.
23
PASS Knob
– Turn to adjust Copilot/Passenger intercom volume or squelch. The
MAN SQ
Key must be
selected to allow squelch adjustment.
24
Display Backup Button
– Manually selects Reversionary Mode.