Garmin G900X Pilot's Manual - page 197
GPS NAVIGATION
190-00726-00 Rev. A
5-39
Garmin G900X Pilot’s Guide
The “direct-to” navigation feature provides a quick method of setting a GPS course to a destination waypoint.
Once a direct-to is activated, the G900X establishes a point-to-point course line from the present position to the
selected direct-to destination. Course guidance is provided until the direct-to is cancelled or replaced by a new
destination.
SELECTING A DIRECT-TO WAYPOINT
A direct-to waypoint can be selected in the following ways:
• By identifier, facility, or the name of a city
• From the active flight plan or nearest airports list
• From a waypoint field, waypoint page, or highlight shortcut
Selecting and activating a direct-to destination by entering an identifier:
1)
Press the
Direct-to
(
)
Key.
2)
Enter the destination waypoint identifier (Figure 5-28).
Figure 5-28 Entering an Identifier
3)
Press the
ENT
Key to confirm the identifier. The ‘Activate?’ field is highlighted (Figure 5-29).
Figure 5-29 Activate Field
Activate Field
4)
If no altitude constraint or course is desired, press the
ENT
Key to activate. To enter an altitude constraint,
proceed to step 5.
5)
Turn the large
FMS
Knob to place the cursor over the ‘VNV’ altitude field (Figure 5-30).