Garmin G900X Pilot's Manual - page 80
Garmin G900X Pilot’s Guide
190-00726-00 Rev. A
2-20
FLIGHT INSTRUMENTS
OBS MODE
NOTE:
VNV is inhibited while automatic waypoint sequencing has been suspended.
Enabling Omni-bearing Selector (OBS) Mode suspends the automatic sequencing of waypoints in a GPS
flight plan (GPS must be the selected navigation source), but retains the current “active-to” waypoint as the
navigation reference even after passing the waypoint. ‘OBS’ is annunciated to the lower right of the aircraft
symbol when OBS Mode is selected (see Figure 2-28).
While OBS Mode is enabled, a course line is drawn through the “active-to” waypoint on the moving map.
If desired, the course to/from the waypoint can now be adjusted. When OBS Mode is disabled, the GPS flight
plan returns to normal operation with automatic sequencing of waypoints, following the course set in OBS
Mode. The flight path on the moving map retains the modified course line.
Enabling/disabling OBS Mode while navigating a GPS flight plan:
1)
Select the
OBS
Softkey to select OBS Mode.
2)
Turn the
CRS
Knob to select the desired course to/from the waypoint. Press the
CRS
Knob to synchronize the
Selected Course with the bearing to the next waypoint.
3)
Select the
OBS
Softkey again to return to automatic waypoint sequencing.
Figure 2-28 Omni-bearing Selector (OBS) Mode
Pressing the
OBS
Softkey Again
Returns to Normal Operation
Pressing the
OBS
Softkey
Suspends Waypoint Sequencing
GPS Selected
Extended
Course Line
OBS Mode
Enabled