Garmin G900X Pilot's Manual - page 371
190-00726-00 Rev. A
Garmin G900X Pilot’s Guide
6-45
HAZARD AVOIDANCE
TRAFFIC MAP PAGE
The Traffic Map Page is specialized to show surrounding TIS traffic data in relation to the aircraft’s current
position and altitude, without clutter from the basemap. Aircraft orientation on this map is always heading up
unless there is no valid heading. Map range is adjustable with the
Joystick
from 2 to 12 nm, as indicated by
the map range rings.
The traffic mode is annunciated in the upper left corner of the Traffic Map Page. When the aircraft is on the
ground, TIS automatically enters Standby Mode. Once the aircraft is airborne, TIS switches from Standby to
Operating Mode and the G900X begins to display traffic information. Refer to the System Status discussion for
more information.
Displaying traffic on the Traffic Map Page:
1)
Turn the large
FMS
Knob to select the Map Page Group.
2)
Turn the small
FMS
Knob to select the second rectangular page icon.
3)
Confirm TIS is in Operating Mode:
Select the
OPERATE
Softkey to begin displaying traffic.
OR
:
a)
Press the
MENU
Key.
b)
Select ‘Operate Mode’ (shown if TIS is in Standby Mode) and press the
ENT
Key.
Figure 6-61 Traffic Map Page
Non-Threat Traffic
Proximity Advisory
1700’ Above, Descending
“Non-Bearing” Traffic
(System Unable to
Determine Bearing)
Distance is 8.0 nm,
1100’ Above,
Descending
Non-Threat Traffic
Traffic Advisory
400’ Below, Climbing
Traffic Status Banner
Traffic Mode Annunciation
“TIS Not Available”
Voice Alert Status
Range Marking Rings
Select to Mute “TIS Not
Available” Voice Alert