Lantronix ETS Reference Manual - page 136
Printing
NetWare Host Setup
8-14
8
Select the name of this file server and press Enter (or just press Enter if no file servers appear).
Figure 8-37: Selecting the File Server
9
Highlight the name of the queue created in step B and press Enter twice, leaving the priority at +1.
10
Exit PCONSOLE by repeatedly pressing Escape.
11
Restart the pserver VAP/NLM/process on the file server or PC.
12
To connect the ETS port to the rprinter file server, complete one of the following steps, depending on
how pserver is running:
13
If pserver is running as a VAP, enter the following on the file server. The pserver name must match
the name you entered on the ETS for the PRINTSERVER.
Figure 8-38: Restarting pserver as a VAP
If pserver is running as an NLM, enter the following:
Figure 8-39: Restarting pserver as an NLM
If pserver is running on a dedicated PC, start it by entering the following:
Figure 8-40: Restarting pserver on a Dedicated PC
At this point, the ETS will connect the port to the rprinter file server, and the port is ready to print from
NetWare. The port will be unavailable for other protocols to use. If the ETS does not connect within one
minute, use the Set/Define Protocols NetWare Reset command to force the ETS to re-scan the NetWare
connections.
File Server
Print Queue
Priority
eng_server
TESTQ
1
docserver
DOCQ
1
labserver
LABQ
1
: STOP
pserver_name
: START
pserver_name
: UNLOAD PSERVER
pserver_name
: LOAD PSERVER
pserver_name
F:> PSERVER
pserver_name