Lantronix ETS Reference Manual - page 246
Set/Define Service Commands
Command Reference
12-84
Restrictions
You must be the privileged user to use this command.
Parameters
mask
Enter a mask in numeric IP format. A 0 in any bit position prevents that bit
from passing while a 1 in any bit position allows the bit to pass through.
Examples
Local> SET SERVER SUBNET MASK 255.255.192.0
See Also
Set/Define Server IPaddress, page 12-69; Set/Define Server Gateway, page 12-
66; TCP/IP, page 2-7; IP Address, page 4-5.
12.46.46 Set/Define Server UUCP
Determines whether the ETS will use the UUCP handler. If enabled, the ETS will listen to TCP/IP port 540
and attempt to connect any logins there to a service called “UUCP” (typically a serial line with an attached
modem).
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Errors
If a UUCP service does not exist, the connection will be closed.
See Also
UUCP Support, page 2-14.
12.47 Set/Define Service Commands
12.47.1 Set/Define Service
Creates a local service. A maximum of 16 services may be configured for the ETS. Additional service
parameters are discussed in the following pages.
Note:
Services have no default parameters; all options must be configured manually.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
SET
DEFINE
SERVER UUCP
ENABLED
DISABLED
SET
DEFINE
SERVICE ServiceName