Lantronix ETS Reference Manual - 12.49.2 Define Slip
Command Reference
Set/Define SLIP
12-97
12.49.2 Define SLIP
Configures SLIP defaults to be used when a user doesn’t explicitly specify options in the Set SLIP
command, or permanent SLIP connections for particular ports.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Note:
Define SLIP Port n implicitly does a Define Port n SLIP Enabled.
Parameters
Default
Specifies default SLIP settings to be used for the port. These settings can be
overridden by user-specified options, or when the Force option is Set.
Port
Specifies SLIP options that are intended to affect the port specified with the
portnumparameter, or the current port (when no portnum is given).
Autostart
If enabled, the port will treat all serial input as SLIP packets and will run SLIP
until the port is logged out. The port will then remain idle until reactivated. If
disabled, any defined parameters will be treated as defaults for that particular
port.
DEFINE SLIP
DEFAULT
BROADCAST
FORCE
ENABLED
DISABLED
MTU
mtuval
RFC
PORT portnum
[
]
AUTOSTART
ENABLED
DISABLED
BROADCAST
FORCE
ENABLED
DISABLED
DEFAULT
IPADDRESS
address
NONE
MTU
DEFAULT
mtuval
RFC