Lantronix ETS Reference Manual - 12.4 Backwards
Backwards
Command Reference
12-4
12.4 Backwards
Switches from the current session to the last session accessed. Repeating the command will cycle you
backward in time through the active sessions, which can be viewed with the Show Sessions command. If
the Backwards command is issued from the first (earliest) session in the session list, the last (most recent)
session is resumed.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Errors
Backward has no effect if there is only one session, and an error is displayed if
no sessions are active.
See Also
Forwards, page 12-13; Set/Define Port Break, page 12-31; Show/Monitor
Sessions, page 12-111; Session Management, page 6-7.
12.5 Bg
Bg is functionally equivalent to the Backwards command (see above). It is provided for UNIX
compatibility.
12.6 Broadcast
Sends a message to one port, all ports, or a particular user on the ETS. This command can only be used if
broadcasts have been enabled on the ETS. The sender will be notified if a message is not received.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use the All parameter.
Errors
An error will result if the destination port is flow controlled, the ETS does not
have broadcast enabled, or the destination session is set to Passthru or Passall
mode.
Parameters
All
The broadcast is sent to all ports.
BACKWARDS
BG
BROADCAST
ALL
PORT number
username
message