Lantronix ETS Reference Manual - page 245
Command Reference
Set/Define Server Commands
12-83
Both the Telnet and NCP consoles are available at the time the ETS attempts to download the startupfile; if
there is a problem with the download, you can still log into the ETS and determine what went wrong.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Parameters
host:filename
Used to load from a TCP/IP host via TFTP.
Enter a TCP/IP hostname or IP address followed by a colon and a startup file
name of up to 47 characters. The entire string should be enclosed in quotes to
preserve case. If you use a text host name, it must be resolvable at boot time.
node::filename
Used to load from a VAX machine via LAT. Enter the nodename followed by
two colons and the startup file name of up to 47 characters.
node\SYS:\LOGIN\filename
Used to load from a Novell fileserver. Enter the proper node and filename. The
path should exceed 47 characters.
None
Clears any previously configured startupfile name, host, and retry setting.
Retry num
Specifies how many times to retry the download attempt. The default is 5. If
zero is specified, the ETS will retry until the startupfile is read (indefinitely).
Examples
Local> DEFINE SERVER STARTUPFILE “bob:start” RETRY 6
Local> DEFINE SERVER START hevax::start.com
Local> DEFINE SERVER STARTUPFILE
engfs\sys:\login\start.cmd”
See Also
Set/Define Server Loadhost, page 12-70; Reloading Operational Software,
page 3-7; Installation Guide.
12.46.45 Set/Define Server Subnet Mask
Sets an IP subnet mask for the ETS, or overrides the subnet automatically created when the IP address was
configured. The mask is applied to target IP addresses to determine whether the destination address is on
the local network segment. If it is not, the ETS’s gateway host will be accessed to provide the connection.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
SET
DEFINE
SERVER SUBNET MASK
[
]
mask