Lantronix ETS Reference Manual - 12.26 Mode
Command Reference
Mode
12-17
12.26 Mode
The Mode command is provided for DOS compatibility; it configures the serial port parameters with both
a Set and a Define command. Note that there should be no spaces between parameters.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Parameters
SerPort
Configure the specified serial port instead of the current port.
baudrate
Enter the port’s baud rate, which can range from 150 to 115,200 baud.
parity
Enter the port’s parity, which can be Even, Odd, Mark, Space, or None.
charsize
Enter the character size, which can be either 7 or 8.
stopbits
Enter the desired stop bit count, which can be either 1 or 2.
Examples
Local> MODE COM4:9600,even,1,7
See Also
Set/Define Port Commands, beginning on page 12-27.
12.27 Monitor
Monitor commands are the same as Show commands, except that the displayed information is continuously
updated approximately every three seconds. The display can be stopped by pressing any key. See the
corresponding Show commands for details and options.
12.28 Netstat
The Netstat command shows the currently active network connections. Information is displayed for the
AppleTalk, LAT, LAN Manager, NetWare and TCP/IP protocols. This information is primarily meant for
debugging network problems.
Applies To
EEPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
MODE COM SerPort:
[
]
baudrate ,parity ,charsize ,stopbits
[
]
[
]
[
]
NETSTAT