Lantronix ETS Reference Manual - 3.8 System Passwords
System Passwords
Getting Started
3-8
◆
NetWare fileserver name
Boot parameters are edited with Set/Define Server commands.
Figure 3-11: Editing Boot Parameters
Note:
The loadfile name must be placed in quotes to preserve case.
3.8 System Passwords
There are three important passwords for the ETS: the privileged password, the login password, and the
maintenance password. All three are discussed in the following sections.
3.8.1 Privileged Password
Changing any server or port setting (and issuing certain other commands) requires privileged user status.
When using EZWebCon, you will be prompted for the privileged password when it is needed. If you are not
using EZWebCon, you must enter the Set Privileged command at the Local> prompt to become the
privileged user.
Figure 3-12: Set Privileged Command
Note:
The prompt may change to reflect privileged user status, if configured to do so.
If another user is currently logged into the ETS as the privileged user, you can use the Set Privileged
Override command to forcibly become the privileged user.
The default privileged password for the ETS is system. To change the privileged password, use the Set/
Define Server Privileged Password command on page 12-76 to enter a new password of up to six
alphanumeric characters. It is not necessary to enclose the password string in quotes; the privileged
password is not case-sensitive.
Figure 3-13: Changing Privileged Password
If you do not provide the password on the command line, you will be prompted to enter it and then verify
your entry. The password will not be displayed on the terminal.
Note:
You can abort the password-entering process by pressing Ctrl-Z at the password
prompt.
Local>> DEFINE SERVER LOADHOST 192.0.1.8 SOFTWARE “newload”
Local> SET PRIVILEGED
Password> system (not echoed)
Local>>
Local> SET PRIVILEGED
Password> system (not echoed)
Local>> SET SERVER PRIVILEGED PASSWORD hippo
Local>> SAVE SERVER PRIVILEGED PASSWORD hippo