Lantronix ETS Reference Manual - page 235
Command Reference
Set/Define Server Commands
12-73
12.46.23 Set/Define Server Name
Specifies the name of the ETS.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Parameters
ServerName
Enter a string of up to 16 alphanumeric characters.
Note:
The ETS name string must be enclosed in quotes to preserve case.
See Also
Show/Monitor/List Server, page 12-108; Changing the Server Name, page 3-5.
12.46.24 Set/Define Server Nameserver
Specifies the IP address of the name server used for TCP/IP connections, if any. This host will attempt to
resolve text Telnet hostnames into numeric form if the local host table cannot do so.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Parameters
Secondary
Allows you to specify a backup nameserver for when the primary nameserver
is unavailable.
IPaddress
Enter the network address of the nameserving host in standard numeric IP
format. Specifying “0.0.0.0” as the address clears the previously-defined
nameserver.
Examples
Local> SET SERVER NAMESERVER 192.0.1.49
Local> SET SERVER SECONDARY NAMESERVER 192.0.1.34
See Also
Define Protocols IP, page 12-57; Show/Monitor/List Protocols IP, page 12-
104; TCP/IP, page 2-7; Editing the Boot Parameters, page 3-7; Other TCP/IP
Parameters, page 4-5.
SET
DEFINE
SERVER NAME ServerName
SET
DEFINE
SERVER SECONDARY
[
]
NAMESERVER IPaddress