Lantronix ETS Reference Manual - 12.36 Save
Command Reference
Save
12-21
Rlogin is shorthand for the Connect Rlogin command, discussed on page 12-9, and is provided for
simplicity. The hostname can be either text or an IP address. If a preferred Telnet service has been defined,
the hostname parameter is optional. If the optional username is specified, it will be used as the login name.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
See Also
Connect, page 12-9; Set/Define Port Preferred, page 12-46; Rlogin, page 2-9.
12.36 Save
Saves current configurations into the permanent database, essentially Defining everything that has been
configured so far using Set commands. Instead of issuing a Define for each Set command to make your
changes permanent, you can just issue the Save command after you have configured a port, service, server
or printer. For example, Save Service “print4me” will save any options configured with Set commands for
a service named “print4me” since the ETS booted.
Note:
You cannot save the login service; you must use the Define Server Incoming
command to make it permanent.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Errors
Save without a parameter is invalid.
Parameters
IPsecurity
Saves the current IPsecurity table.
Menu
Saves all menu items set up with Set Menu commands.
Port
Saves the settings for a selected port or all ports. If the Port parameter is used
without the All or portnumkeywords, the current port is saved.
Server
Saves the current ETS settings.
SAVE
IPSECURITY
MENU
PORT
ALL
portnum
PRINTER
SERVER
SERVICE
ALL
name
SNMP