Lantronix ETS Reference Manual - 12.8 Close
Command Reference
Close
12-9
Errors
Clear Hosts will fail if there are active Telnet connections on the ETS.
Parameters
HostName
Removes only the specified host.
All
Removes all entries from the host table.
Examples
Local> CLEAR HOSTS “alex”
See Also
Set/Define Telnet Hosts, page 12-99; Show/Monitor/List [Telnet] Hosts, page
12-113; Telnet, page 2-8.
12.8 Close
See Disconnect on page 12-12.
12.9 Cls
Clears the screen on your terminal device if the port is configured as Type ANSI.
Applies To
ETS4P, ETS8, ETS8P, ETS16, ETS16P
See Also
Set/Define Port Type, page 12-54.
12.10 Connect
Establishes a session with a LAT service or TCP/IP host. If no service or hostname is specified, a connection
to any preferred service or host is attempted. A session environment string can be added to the connect
request (refer to Environment Strings on page 2-15). A colon and port number can also be added to the
hostname for TCP/Telnet/Rlogin sessions; in this case the specified port number will be used for the
connection.
CLS
CONNECT
LAT
[
]
servicename
NODE NodeName
DESTINATION port
ENVIRONMENT EnvString
TELNET hostname :EnvString
[
]
RLOGIN hostname username
[
]
TCP hostname