Lantronix ETS Reference Manual - page 213
Command Reference
Set/Define Port Commands
12-51
Parameters
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
Note:
In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
See Also
Show/Monitor/List Ports, page 12-102; DSR for Controlling Remote Logins,
page 5-8.
12.43.36 Set/Define Port SLIP
Determines whether the port will be able to start SLIP sessions with the Set SLIP command. Define SLIP
Port n implicitly enables SLIP on the port.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Errors
SLIP cannot be configured for Virtual ports (Port 0).
Parameters
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
Note:
In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
See Also
Clear/Purge SLIP, page 12-8; Set/Define SLIP, page 12-95; Show/List SLIP,
page 12-112; Show/Monitor/List Ports, page 12-102; Serial Line Internet
Protocol (SLIP), page 2-12; SLIP, page 4-6.
12.43.37 Set/Define Port Speed
Configures what baud rate will be used for connections to and from this port.
SET
DEFINE
PORT
PortList
ALL
SLIP
ENABLED
DISABLED
DEDICATED
SET
DEFINE
PORT
PortList
ALL
SPEED baudrate