Lantronix ETS Reference Manual - 12.11 Crash 451
Command Reference
Crash 451
12-11
Rlogin hostname
Enter a text host name or IP address for the connection.
TCP hostname
Creates a raw TCP connection to the host (no Telnet data interpretation is
performed).
Examples
Local> CONNECT
Local> CONNECT LOCAL
Local> CONNECT vax6 ENVIRON +e
Local> CONNECT wampum NODE opus DESTINATION port_2
Local> CONNECT RLOGIN 145.34.35.14
Local> CONNECT TELNET 145.34.35.11:245
Local> CONNECT TCP labsun
See Also
Attach Port, page 12-2; Set/Define Port Preferred, page 12-46; Environment
Strings, page 2-15.
12.11 Crash 451
Immediately reboots the ETS. All users are logged off and sessions are disconnected. If upline dumping is
enabled, the ETS generates a dump file on the VMS load host before rebooting.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
See Also
Initialize, page 12-14; Rebooting the Server, page 3-6.
12.12 Define
Define is equivalent to Set, but Define changes the permanent characteristics of ports, servers, and services.
Define Port and Define SLIP settings do not take effect until after the current user logs out. Define Server,
Define Telnet Host, and Define Service settings remain unchanged until the ETS is rebooted. To make a
permanent change that takes effect immediately, you must enter both a Define and a Set command with the
same parameters. All Define commands are documented together with their corresponding Set commands
later in this chapter.
CRASH 451