Lantronix ETS Reference Manual - 3.4.3   Clear and Purge

Getting Started

Abbreviating Keywords

3-5

List

Displays the unit’s permanent settings. Note that some settings that are Listed 

will not take effect until the unit is rebooted.

3.4.3   Clear and Purge

Clear

Removes an item immediately, but not permanently. When the unit is 

rebooted, the old setting will again be in effect.

Purge

Removes an item permanently, but generally does not take effect until the unit 

is rebooted. Purge Port will take effect as soon as the port is logged out and 

Purge SLIP will take effect as soon as the current SLIP session (if any) ends.

3.5   Abbreviating Keywords

When configuring the ETS via the command line, it is only necessary to type as many characters as are 

needed to distinguish the keywords from one another. For example, the following two commands are 

equivalent:

Figure 3-4:  Full and Abbreviated Commands

Note:

Extra white space (more than one consecutive space between keywords) is 

ignored.

3.6   Maintenance Issues

The following sections detail configuration that is required on a sporadic or ongoing basis. 

3.6.1   Changing the Server Name

The ETS is initially configured with a server name. However, you can give the ETS a custom name of up 

to 16 alphanumeric characters using the following command:

Figure 3-5:  Changing the Server Name

The ETS name string must be enclosed in quotes if lowercase letters are used.

Local>> DEFINE PORT 2 BROADCAST ENABLED AUTOCONNECT ENABLED PARITY EVEN 

SPEED 4800

Local>> DEF PO 2 BRO EN AUTOC EN PAR E SP 4800

Local>> DEFINE SERVER NAME “PrintServer”