Lantronix ETS Reference Manual - page 231
Command Reference
Set/Define Server Commands
12-69
Both
Enables incoming LAT and Telnet connections, and creates a new LAT
service that is used to log into the ETS.
None
Disables incoming LAT and Telnet connections (the default).
It also removes any LAT-created or Both-created service and the ability to log
in using LAT.
Nopassword
Allows the establishment of incoming connections without prompting for a
password (the default).
Password
Causes the ETS to prompt for a password for all incoming connections.
Examples
Local> SET SERVER INCOMING TELNET INCOM PASSW
(sets up password protected Telnet logins)
See Also
Show/Monitor/List Server, page 12-108; LAT and TCP/IP Connectivity, page
2-15; System Passwords, page 3-8.
12.46.16 Set/Define Server IPaddress
Sets the ETS’s IP network address. The IP address must be set before any TCP/IP connectivity is available
(i.e., Telnet, Rlogin, and Reverse Telnet) and before EZWebCon can be used. It cannot be changed when
there are active TCP/IP sessions. A default subnet mask will also be created when you set the IP address; it
can be overridden with the Set ETS Subnet Mask command.
Note:
If the IP address is cleared after a reboot but List ETS still shows the address,
there is some other node on the network responding to that IP address.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Errors
Configuring an IP address will automatically disable DHCP.
Parameters
IPaddress
Enter the address in standard numeric format.
Examples
Local> SET SERVER IPADDRESS 192.0.1.49
SET
DEFINE
SERVER IPADDRESS IPaddress