Lantronix ETS Reference Manual - page 208
Set/Define Port Commands
Command Reference
12-46
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Parameters
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
Note:
In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
See Also
Set/Define Server Login Password, page 12-71; Show/Monitor/List Ports,
page 12-102; System Passwords, page 3-8; Password Restrictions, page 5-14.
12.43.29 Set/Define Port Preferred
Specifies a default service (either LAT or Telnet) for this port. The ETS will attempt to use the preferred
service for Autoconnecting, and when no service name is specified in a Connect, Telnet, or Rlogin
command. Note that via the environment string, a preferred host can be connected to via Rlogin, not just
Telnet.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Parameters
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
Note:
In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
None
Clears any previously-configured preferred host.
SET
DEFINE
PORT
PortList
ALL
PREFERRED
NONE
SERVICE ServiceName
DESTINATION Port
ENVIRONMENT EnvString
NODE NodeName
TELNET
hostname :EnvString
NONE